Solutions
Quick repair of cracks, joints and delamination in the concrete
Quick repair of cracks, joints and delamination in the concrete
Save time and money with a crack repair system that fully cures in 10 minutes!
Roadware 10 Minute Concrete Mender™ “The advanced concrete repair material that repairs concrete from the inside out.”
Now you can repair cracks and spalls to a smooth finish in a fraction of the time it takes with ordinary products. Roadware 10 Minute Concrete Mender™ is a revolutionary new two part hybrid urethane for repairing concrete. It’s nearly water thin for deep penetration and it won’t pop out like epoxy because it never gets brittle. No pot-mixing and no waste. Roadware 10 Minute Concrete Mender™ is packaged in uniquely designed ratio-packs that completely mix the material at the point of application. No pot-mixing and no unused material. Difficult repairs are now simple, just clean the area, prime with 10 Minute Concrete Mender, add manufactured sand, and flood with additional 10 Minute Concrete Mender. In 10 minutes you’ll get a tough 4500 psi polymer concrete that will stay in place permanently. Great for all in dustrial floors. Roadware 10 Minute Concrete Mender™ is extremely tough and will withstand even the harshest punishment. Great for freezers... may be applied at temperatures as low as -35°C with excellent results. High chemical resistance, perfect for containment areas. Re-coat in 10 minutes, will accept primers and industrial coatings in just 10 minutes after application. Now prepwork and coatings can be applied in the same day!
Roadware 10 Minute Concrete Mender™ Benefits and Features
- Permanent repair - doesn’t pop out
- Cures in ten minutes for traffic or coating • Quick and easy surface preparation - no saw cuts necessary
- No minimum or maximum depth restrictions
- Low installed cost vs. alternatives
- Cures in temperatures down to -20° F
- Bonds to concrete, masonry, steel & wood
- Compatible with all floor coatings
- Moisture tolerant
- No shrinkage - 6% elongation
- Excellent chemical resistance
- Extremely thin - low surface tension
- Cure stops at 4500 psi
- Dynamic load transfer
- Can be used as a coating
- Can be painted
- Polishes and Grinds well
- Resealable tubes - not pot mixed - eliminates waste
- Meets USDA guidelines
- Local stocking distributor
